Deflex 324


Technical description

Overlay profile, made of aluminium and a flexible elastomer inlay, foreseen for installation on finished interior and exterior building surfaces. May be used for finishing of expansion slits both on walls and on ceilings, with any kind of surface finish type.
Thanks to the use of an accordion elastomer inlay, the profile is characterised by very good ability to compensate for movement of the building both horizontally as well as vertically (slip joint of the inlay with the profile), and is particularly recommended for areas with mining damage. The profile structure allows replacement of the elastomer inlay without the need to remove the aluminium profiles. The use of an additional elastomer inlay increases expansion slit protection against intrusions of water and humidity to the building interior.
An advantage of the series 324 expansion profile is the option of installing it outside of the expansion slit, allowing its use in spots where the expansion slits do not run straight and have varied widths. In addition, the use of a cellulose rubber layer from the underside of the installation profiles allows evening out of subsurface unevenness during installation. Profile is particularly recommended for finishing work on expansion slits in building façades, particularly its corners, with any wall angles. Profile conforms to fire resistance requirements for class E according to standard PN-EN 13501-1. 
Profile available in flat and corner form with any angle.

Adhere to notices and remarks concerning installation.

Technical details
Flat bar profiles 324-030
324-050
324-080
324-120
324-200
324-280
324-350
Corner profiles E 324-030
E 324-050
E 324-080
E 324-120
324-200
E 324-280
E 324-350
Fb [mm]
Nominal expansion slit width 30
50
80
120
200
280 350

B [mm]
Total expansion profile width 130
150
180
220 350
380 450

S [mm]
Visible profile width after installation 130
150
180
220
350
380
450

H [mm]
Installed height 15
15
15
15
15
15
15

BE [mm]
Total expansion profile width 90
110
140 180
310 340
410

SE [mm]
Visible profile width after 90
110
140
180
310
340
410

HE [mm]
Installed height 45
45
45
45
45
45
45
W ± [mm]
Expansion slit movement compensation 10 (+8/-2) 30 (+20/-10) 45 (+30/-15)
65 (+45/-20)
90 (+50/-40) 125 (+80/-45)
150 (+100/-50)
Colour aluminium - natural, elastic inlay - black and grey 1)
Material Aluminium load bearing profiles conforming to standard PN-EN 755.
Besaflex elastic inlay - outdoor material, resistant to aging, oxidation, atmospheric influences and temperature fluctuations (from -30 °C to +60 °C), as well as influences by i. e. acids and bases. The elastic inlay is manufactured according to plant standards.
Standard length[m] Load bearing profiles - 4, elastic inlay - 20 2)
1) Upon request, the profile may be manufactured in any RAL colour - at extra cost.
2) Inlays may be manufactured in sections exceeding 20 m in length upon request

 

Installation diagrams

DEFLEX 324

DEFLEX E 324

DEFLEX 324